Water Damage Restoration in Keller, TX

A pipe burst, a water heater leak, or a wet slab does not wait. SureDry handles water damage restoration in Keller from the first call to the last moisture reading.

We pull out the water. We dry the walls, floors, and framing. Then we measure, so you know the house is dry before we leave.

Drawing of a water stain on a wall with three moisture readings: 38 percent on day one, 19 percent on day three, 12 percent dry goal Day 1 · wall38% Day 3 · wall19% Dry goal12%
Example drying log. We record readings like these on your job.
Water removalPumps and extractors
Moisture mappingFind hidden wet spots
Structural dryingAir movers and dehumidifiers
Dry checkReadings before we leave

What to Do in the First Hour

What you do before we arrive matters. These steps limit the damage and keep you safe.

Safety first. If water touches outlets, the breaker panel, or appliances, stay out. Call an electrician.
  • Stop the waterShut off the main valve. Most Keller homes have it near the front hose bib or in the garage.
  • Cut power to wet areasFlip the breaker only if the panel is dry and you can reach it safely.
  • Lift what you canMove rugs, books, and small furniture to a dry room. Put foil under heavy furniture legs.
  • Take photos and videoShoot every wet room before you move things. Your insurer will ask for them.
  • Call us and your insurerDrying starts the same day. Mold can start within 48 hours.

Why Water Damage Happens in Keller Homes

Keller sits in North Texas. Clay soil, hot summers, hard freezes, and hail all push water into homes. These are the causes we see most.

Burst or leaking pipes

Freezing nights can split a pipe in an attic or exterior wall. Winter Storm Uri in 2021 showed how fast it happens.

Slab and plumbing leaks

North Texas clay swells and shrinks. The ground moves, and pipes under the slab can crack.

Water heater failures

Tanks rust out with age. A failed tank can pour out 40 to 50 gallons fast.

AC drain overflow

Summer AC units make gallons of water a day. A clogged drain line sends it into the ceiling or closet.

Washer, dishwasher, and fridge lines

Old rubber hoses split. These leaks often run behind cabinets before anyone sees them.

Irrigation line breaks

A broken sprinkler line near the foundation can push water under the house or into a wall.

Hail and storm roof leaks

North Texas storms damage shingles. Rain then enters the attic and soaks insulation and drywall.

Sewer backups

Heavy rain and clogged lines can push dirty water up a floor drain. This needs a different cleanup plan.

Our Water Damage Restoration Process in Keller

Good drying follows a plan. The industry standard, ANSI/IICRC S500, sets the rules. We follow the same steps on every job.

  1. Inspect and find the source

    We find where the water came from and where it went. Then we stop the source, or confirm someone has.

  2. Remove the water

    Pumps and extractors pull standing water out of floors and carpet. Fast removal means less water in the walls.

  3. Dry the structure

    Wet drywall, framing, and subfloor hold water long after the surface looks dry. We dry them in place when we can.

    Air movers and dehumidifiers

    Air movers push air across wet surfaces. Dehumidifiers pull the moisture out of the air so it does not settle back.

    Daily moisture checks

    We use a moisture meter and map each wet area. We adjust the equipment until the readings drop.

  4. Clean up and remove what you cannot save

    We remove soaked insulation, pad, and ruined drywall. We clean and treat surfaces that stay.

  5. Confirm it is dry

    We take a final reading and compare it to a dry area of the same material. Then we remove the equipment.

Clean, Gray, or Black Water: What Changes

Not all water is the same. The type decides what we can save and how we protect your family.

Water categories under ANSI/IICRC S500
CategoryCommon sourcesHealth riskWhat we usually do
1 · CleanBroken supply line, tub overflow, rain from a clean sourceLow at first, but it rises with timeExtract and dry. Most materials can stay.
2 · GrayWasher or dishwasher overflow, sump pump failure, aged clean waterCan cause illness if swallowed or touchedExtract, clean, and disinfect. Remove soaked carpet pad.
3 · BlackSewage, creek or river flooding, long-standing waterHigh. Contains germs and waste.Remove porous materials. Clean and disinfect with protective gear.

Source: IICRC S500 standard. Clean water turns gray and then black the longer it sits.

Fans and a Shop Vac vs. Professional Drying

A small spill is a fair DIY job. A wet wall or floor is not. Here is the difference.

DIY cleanup compared with professional drying
What mattersDIY with fans and a shop vacProfessional restoration
Hidden moistureYou cannot see water inside walls or under floors.Moisture meters and thermal cameras find it.
Drying speedBox fans move air but do not remove moisture.Air movers and dehumidifiers dry a room in days.
Proof it is dryIt feels dry. You guess.Daily readings and a final dry reading.
Mold riskHigher if any wet spot stays.Lower, because we dry to a set goal.
Unsafe waterNot safe to handle without gear.Trained crew with protective gear.
Insurance recordsPhotos only.Photos, readings, and an equipment log.

Does Texas Homeowners Insurance Cover Water Damage?

Often, yes, if the water was sudden and accidental. A burst pipe or a failed water heater usually counts.

Slow leaks that went on for weeks are often not covered. Flood is not covered by a standard homeowners policy. It needs its own flood policy.

Steps that protect your claim

  • Call your insurer as soon as you can.
  • Stop the damage. Your policy expects you to protect the home.
  • Keep wet items until the adjuster sees them.
  • Keep receipts for hotel stays and repairs.

Read more: Texas Department of Insurance, homeowners guide · FEMA FloodSmart

Mold After Water Damage

Mold needs water, food, and time. Drywall, wood, and carpet give it food. Wet conditions give it time.

Dry the area in 24 to 48 hours and mold often never starts. This is the EPA's advice, and it is why we start drying the same day.

Sources: EPA, mold cleanup in your home · Texas TDLR mold FAQ

10 sq ftEPA guide: most homeowners can clean mold smaller than this. Larger areas call for a pro.

25 sq ftTexas law: mold across 25 contiguous square feet or more needs a licensed assessor and a separate licensed remediator.

How Much Does Water Damage Restoration Cost in Keller?

We do not quote a price over the phone for a wet house. Every job is different. We inspect first and give you a written price.

Five things move the price most. Fast action usually means a lower bill, so call early.

General U.S. price guide for drying and cleanup, per square foot
Water typeTypical rangeExample
Category 1 · CleanAbout $3 to $4Broken supply line
Category 2 · GrayAbout $4 to $6.50Washer overflow
Category 3 · BlackAbout $7 to $7.50Sewage backup

National averages from HomeAdvisor. HomeAdvisor reports a $3,868 average job and a $1,383 to $6,369 range for most homeowners. These are general figures, not SureDry prices. Repairs after drying, like drywall and flooring, cost extra. Last reviewed: October 2026. Check the source links for current figures.

  • Size of the wet areaMore rooms and more square feet mean more equipment and time.
  • Type of waterSewage and storm water cost more than a clean pipe leak.
  • Time since the leakWater that sat for days soaks deeper and may cause mold.
  • MaterialsHardwood, tile over slab, and thick walls dry slowly. Carpet pad is often replaced.
  • Drying daysMost jobs run three to five days. Equipment stays until the readings pass.

Water Damage Before and After

These example photos show common water damage and the drying work that follows.

Small kitchen with a collapsed ceiling section, pink insulation and debris on the floor
Before
The same kitchen cleaned and repaired, with a clear floor and a finished ceiling
After
Water stain and peeling paint on a vaulted ceiling above a staircase
Before
The same vaulted ceiling repaired and repainted with no stain
After
Red air movers, a blue dehumidifier, and a large red drying unit set around a living room floor after carpet removal
Drying equipment around a wet living room floor. Example photo.
Technician pressing a moisture meter against carpet at the base of a stained wall
A moisture meter checks a wall base and carpet. Example photo.

Where We Work Around Keller

Our office is on South Main Street in Keller. We serve homes across the 76248 and 76244 ZIP codes and nearby North Tarrant County.

Not sure we cover your street? Call (817) 803-8185 and we will tell you. See the full water damage service area.

Water Damage Questions Keller Homeowners Ask

How much does water damage cleanup cost in Keller, TX?

It depends on the size of the area, the type of water, and how long it sat. A small clean-water leak costs far less than a sewage backup. We inspect first, then give you a price before work starts.

How long does it take to dry a house after water damage?

Most homes need about three to five days of drying. Soaked floors or thick walls can take longer. We check moisture readings each day and stop only when the materials reach a dry level.

Does homeowners insurance cover water damage in Texas?

Most Texas policies cover sudden and accidental water damage, like a burst pipe. They often exclude slow leaks and flood. Read your policy and call your insurer early. The Texas Department of Insurance explains the basics.

Can I dry water damage myself?

You can handle a small clean spill on a hard floor with towels and a fan. Wet drywall, insulation, carpet pad, or a wet slab needs pro equipment. Water hides inside walls, and hidden water grows mold.

How fast does mold grow after water damage?

Mold can start in 24 to 48 hours, according to the EPA. That is why fast drying matters. If you see mold after a leak, do not mix cleaners. Call us for an inspection.

Is it safe to stay in my home after a leak?

It depends on the water. Clean water from a supply line is usually safe once the power is off. Sewage or storm water is not. If water touched outlets or the panel, stay out and call an electrician.

What should I do first when a pipe bursts?

Shut off the main water valve. Turn off power to wet areas if you can do it safely. Move small items out of the water. Take photos. Then call a restoration company and your insurer.

Will you work with my insurance company?

We take photos and keep daily moisture readings. Your adjuster can use these records. You still file the claim with your insurer, and they decide what the policy pays.

Do I need flood insurance for water damage in Keller?

Standard homeowners policies do not cover flood. Flood coverage is a separate policy. The National Flood Insurance Program usually has a 30-day wait. You cannot buy it when a storm is already coming.

Water in Your Keller Home? Call Now.

Every hour makes water damage harder to fix. SureDry offers water damage restoration in Keller, TX, with daily readings that show the work. Call and tell us what happened.

Call (817) 803-8185

Call (817) 803-8185